Point Selection - Mitsubishi Electric FATEC MELSEC iQ-R Training Manual

6.8.5

Point selection

Perform operation on the positioning operation screen in the same manner as in the case of
the standby point positioning.
(3) Touch
point input in (2).
M11 is on during point selection positioning operation.
The point selection positioning trajectory is as shown below.
(Current position)
POINT
The speed can be changed during positioning operation. For the speed change, refer to
Section 6.8.7.
Position selection
, and the Axis 1 will be positioned in the address corresponding to the
M1
Point
30 31
40 mm 80 mm
(1) Touch the set value of D2000 setting, and the
numeric input window will appear.
(2) Input one of 30, 31 and 32, and touch
reflect the input value.
The positioning address for each point (input
value) is shown below.
POINT Positioning address (mm)
30
31
32
[Operation example]
Address indirect specification positioning
from (20, -5) to point 32
32
Axis 1
120 mm
(4) Upon completion of the address indirect
specification positioning, check that the positioning
address of X-axis in the feed current value field
corresponds to the point set in (2).
6-50
to
ENTER
40.0
80.0
120.0