Nop Instruction - Mitsubishi Electric FATEC MELSEC iQ-R Training Manual

4.10.11 NOP instruction

NOP (NOP instruction)
The NOP instruction is used for the nonexecutable control method.
The positioning data No. to which the NOP instruction is set transfers, without any
processing, to the operation for the next positioning data No.
When using the NOP instruction, set the following positioning data.
: Always set, : Set as required, : Setting restricted, -: Setting not required
Parameters
[Da.1] Operation pattern
[Da.2] Control modes
[Da.3] Acceleration time No.
[Da.4] Deceleration time No.
[Da.6] Positioning address/movement amount
[Da.7] Arc address
[Da.8] Command speed
[Da.9] Dwell time/JUMP destination positioning data No.
M code/Condition data No./No. of LOOP to LEND repetitions/No.
[Da.10]
of pitches
[Da.20] Axis to be interpolated No.1
[Da.21] Axis to be interpolated No.2
[Da.22] Axis to be interpolated No.3
[Da.27] M code ON signal output timing
[Da.28] ABS direction in degrees
[Da.29] Interpolation speed designation method
Setting item
4-103
Setting required/not required
-
NOP instruction
-
-
-
-
-
-
-
-
-
-
-
-
-