6.8
Demonstration Machine Operation
Execute the positioning operations in accordance with the programs stated in Section 6.6
operating the demonstration machine operation panel.
If any positioning operation cannot be performed, refer to the troubleshooting (Section 6.8.8).
To confirm the current value of each parameter, use the Simple Motion Monitor. (refer to
Appendix 5.)
6.8.1
Starting the servo amplifiers
(1) Set the CPU module RUN/STOP/RESET switch to
"RUN".
(2) The startup screen will appear. Touch
display the course selection screen.
iQ-R Simple motion
(3) Touch
Course
screen to display the screen switching menu.
Servo ON
(4) Touch
M1000
and the servo amplifiers of Axis 1 to Axis 3 will
start.
6-44
OK
on the course selection
on the screen switching menu,
to