Standby Point Positioning - Mitsubishi Electric FATEC MELSEC iQ-R Training Manual

6.8.4

Standby point positioning

Positioning
graph
(1) Touch
(2) Touch
(3) Touch
Standby point
positioning start
Go to next page
6-48
on the screen switching
Positioning control
menu.
Positioning operation screen appears.
Positioning
on the positioning operation
operation
screen to turn on the positioning command
M6001, and the positioning operation screen will
be operable.
Standby point
, and the Axis 1 will be moved
M0
from the current position to the standby point
address (0).
M10 is on during standby point positioning
operation.
The positioning trajectory obtained on the
positioning operation screen is displayed in the
positioning graph.
It is recommended to perform the standby point
positioning after positioning by JOG operation.