Table of Contents
Advertisement
MDS 05-4670A01, Rev. E
3. Press the
key
ENTER
choose and select the correct baud rate. This will result in
prompt.
PC Running Terminal Session
Figure 17. PC Connection to Transceiver
NOTE: TX and RX frequencies might not be set when the radio is
shipped from the factory, depending on ordering options. If
frequencies have not been set, the
cating an alarm condition. The alarm will clear after the
frequencies are set. In all cases, users should verify that the
frequencies are properly set in accordance with the station
license.
6.0 TRANSCEIVER MANAGEMENT
To perform transceiver management, connect a PC as described in
Section 5.1, Initial Startup & Checkout and obtain the
6.1 Software Commands
Table 11 is a reference chart of software commands for the transceiver.
Programmable information is shown in brackets [ ] following the com-
mand name. See Section 6.2, Detailed Command Descriptions (Page
21) for detailed command descriptions.
Entering Commands
To enter a command, type the command, followed by
gramming commands, the command is followed by
appropriate information or values, then
Table 11. Command Summary
Command name
AK Details Page 25
ALARM Details Page 25
AMASK [0000 0000–FFFF
FFFF] Details Page 25
SD Series Reference Manual (x710 Mode)
several times at half-second intervals to
Invisible place holder
Transceiver
DB-9M to COM1 Port
PWR
ENTER
Function
The Authorization Key and a list of authorized
features.
Read current operating condition of radio.
Set/display hex code identifying which events
trigger an alarm.
the
>
LED will flash, indi-
prompt.
>
. For pro-
ENTER
and the
SPACE
.
21
Advertisement
Table of Contents
