Audio [On, Off]; Baud [Xxxxx Abc]; Bin [Data, Clear]; Boot - GE DS-SD4-1 Reference Manual

Table of Contents

Advertisement

Audio Monitor/
Orderwire Status
Data Interface Port
Baud Rate
Data Counters
Software Reboot
RX Data Buffer
26

AUDIO [ON, OFF]

Used to set or display Audio Monitor/Orderwire functionality (on or
off). If
is selected, the radio's transmit functionality will
AUDIO ON
switch to analog whenever PTT is asserted.

BAUD [xxxxx abc]

This command sets (or displays) the communication attributes for the
port (COM2). It has no effect on the
DATA INTERFACE
ment port.
The first parameter (
bits-per-second (bps) and must be one of the following speeds: 300,
1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200 bps.
The second parameter of the
block indicating how the data is encoded:
= Data bits (7 or 8)
a
= Parity (N for None, O for Odd, E for Even)
b
= Stop bits (1 or 2)
c
The factory default setting is 9600 baud, 8 data bits, no parity, 1 stop bit
(Example:
9600 8N1

BIN [DATA, CLEAR]

Used to display or clear the data counters. Use
to clear the counters.
BIN CLEAR

BOOT

Used to initiate a software reboot. Use
rently running firmware image. Use
reboot to a specific firmware image.

BUFF [ON, OFF]

This command sets or displays the received data handling mode of the
radio. The command parameter is either
The setting of this parameter affects the timing of how received RF data
is sent from the
DATA INTERFACE
data is not affected by this setting.
If data buffering is
average latency. Data bytes are sent from the
soon as an incoming RF data frame is disassembled. Average and typ-
ical latency will be minimized, but idle character gaps may be intro-
duced into the outgoing data flow.
SD Series Reference Manual (x710 Mode)
) is baud rate. Baud rate is specified in
xxxxx
command (
BAUD
).
BOOT
BOOT 1
ON
connector. Outgoing (transmitted)
, the radio operates with the lowest possible
OFF
manage-
COM1
) is a three-character
abc
to display. Use
BIN DATA
alone to reboot the cur-
,
, or
BOOT 2
BOOT OTHER
or
. The default is
OFF
port as
DATA INTERFACE
MDS 05-4670A01, Rev. E
to
.
ON

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mds sd series

Table of Contents