Table of Contents
Advertisement
22
Table 11. Command Summary (Continued)
Command name
ASENSE [HI, LO] Details
Page 25
AUDIO [ON, OFF] Details
Page 26
BAUD [xxxxx abc] Details
Page 26
BIN [DATA, CLEAR]
Details Page 26
BOOT Details Page 26
BUFF [ON, OFF] Details
Page 26
CKEY [ON–OFF] Details
Page 27
CTS [0–255] Details Page
27
CTSHOLD [0–60000]
Details Page 27
DATAKEY [ON, OFF]
Details Page 28
DEV Details Page 28
DEVICE [DCE, CTS KEY]
Details Page 28
DKEY Details Page 28
DLINK [ON/OFF/xxxx]
Details Page 28
DTYPE [NODE/ROOT]
Details Page 29
DUMP Details Page 29
EMP [ON/OFF] Details
Page 29
ETHADDR Details Page 29
FORCEALARM [ON or
OFF] Details Page 29
FORCEDCD [ON or OFF]
Details Page 29
HELP Details Page 29
INIT Details Page 30
INIT [SDx] Details Page 30
SD Series Reference Manual (x710 Mode)
Function
Set/display the state of the alarm output signal to
ACTIVE HI or ACTIVE LO.
Set/display the receive audio monitor mode for
modems.
Set/display the DATA INTERFACE data rate and
format.
Display or clear data counters.
Used to initiate a software reboot.
Enables or disables the internal radio data buffer.
Enables or disables the continuously keyed
mode. Note: Remotes cannot receive when
keyed.
Set/display the Clear-to-Send delay in seconds.
Set/display Clear-to-Send hold delay.
Enables or Disables key-on-data mode
(ON = key-on-data or RTS, OFF = key-on-RTS).
Set/display modem control deviation.
Set/display device mode.
Dekey the radio (transmitter OFF). This is
generally a radio test command.
Configures local diagnostic link protocol.
(diagnostics) Sets up a radio as a root or node
radio.
Display all programmable settings.
Set/display TX audio pre-emphasis for analog
mode.
Displays Ethernet MAC address
(non-configurable).
Generates a test alarm for 10 sec.
Forces Data Carrier Detect (DCD) to always be
asserted.
Shows available commands.
Set radio parameters to factory defaults for the
radio outside the P-20 Protected Network
Chassis.
Configure radio for use outside of the Protected
Network Chassis (SDxP). Restores certain
transceiver defaults changed by the INIT P-20
command.
MDS 05-4670A01, Rev. E
Advertisement
Table of Contents
