GE DS-SD4-1 Reference Manual page 63

MDS 05-4670A01, Rev. E
PC Running Terminal Session
Figure 23. PC Connection to Transceiver (Serial)
Follow the steps below for serial transfer upgrade.
NOTE: Serial reprogramming takes several minutes at 115200 bps
baud rate (the recommended speed), but reprogramming is
possible at lower baud rates.
1. Launch a terminal session to the radio with the following
communications parameters: Baud 115200, 8 data bits, no parity,
one stop bit (8N1), XON/XOFF flow control, and VT100 emulation.
2. At the prompt, enter
>
.
yes
3. At the prompt, enter
LOADER>
returned.
4. At the prompt, enter
LOADER>
acters at the prompt.
5. From the terminal program, quickly select
and choose the correct file/file folder on the PC where the
ware file is located.
This process initiates the file transfer and causes the radio to repro-
gram the inactive image. When using HyperTerminal to perform
reprogramming, no status indication is available.
6. Programming is complete when
prompt. The active image has now been changed to the new
package. If this message is not seen, reprogramming did not com-
plete successfully and must be attempted again.
7. Reboot the unit by typing the
This completes the serial upgrade procedure. To verify that the radio
is running the newly loaded firmware image, enter the
mand after rebooting.
SD Series Reference Manual (x710 Mode)
Invisible place holder
Transceiver
DB-9M to COM1 Port
. At the
program ARE YOU SURE?
. The response
erase
. Do not type any more char-
program
Transfer->Send Text File
PROGRAMMED OK
command at the
exit
prompt, enter
is
ERASED OK
firm-
.s28
appears at the
prompt.
LOADER>
com-
srev
53