GE DS-SD4-1 Reference Manual page 54

MDS 05-4670A01, Rev. E
Duty Cycle:
Output Impedance:
Product
SD1
SD2
SD4
SD9
:
DATA CHARACTERISTICS
Signaling Types:
COM2 Data Rates:
Data Latency:
PRIMARY POWER
Voltage:
NOTE: Early SD4 models supported 10.5 to 16 Vdc power, not 10 to 30 Vdc. Check the
labeling above the power connector to confirm the operating range for your unit.
TX Supply Current (Typical):
RX Supply Current (Typical):
Fuse:
ENVIRONMENTAL
Humidity:
Temperature Range:
Weight (nominal):
Transceiver Dimensions:
DIAGNOSTICS INTERFACE
Signaling Standard:
Connector:
All specifications are subject to change without notice or obligation to
any party.
SD Series Reference Manual (x710 Mode)
Variable up to 100%, dependent on application.
Continuous key operation not recommended.
50 Ω
FCC ID
E5MDS-SD1 101D-SD1
E5MDS-SD2 101D-SD2
E5MDS-SD2-1
E5MDS-SD4 101D-SD4
E5MDS-SD4-1 101D-SD4-1
E5MDS-SD9 101D-SD9
E5MDS-SD9-1
RS-232/485; DB-9 Female connector
Ethernet 10/100 Mbps; RJ-45F connector
300–115200 bps, asynchronous
11 ms to 12 ms typical (transparent)
10.0 to 30 Vdc (Negative ground only)
2.5 A maximum @ 5 W RF Output
Operational—150 mA, Nominal
Sleep—<15 mA typical @ 13.8 Vdc
5 A, internal
SD1: 95% at 70°C (158°F), non-condensing
SD2: 95% at 40°C (104°F), non-condensing
SD4: 95% at 70°C (158°F), non-condensing
SD9: 95% at 40°C (104°F), non-condensing
–40 to 70°C (–40°F to 158°F)
1.22 lbs. (0.55 kg)
6.5" long (16.51 cm)
4.625" wide (11.75 cm)
1.5" High (3.81 cm)
RS-232 (COM1)
RS-232/RS-485 (COM2)
COM1—DB-9F
COM2—DB-9F
IC ID
44