GE DS-SD4-1 Reference Manual page 33

MDS 05-4670A01, Rev. E
Table 11. Command Summary (Continued)
Command name
INIT [P-20] Details Page 30
IPCONFIG Details Page 31
KEY Details Page 31
MENU Details Page 31
MODEL1 Details Page 31
MODEL2 Details Page 31
MODEM [xxxx] Details
Page 31
OWM [XXX...] Details Page
33
OWN [XXX...] Details Page
33
PORT [RS232, RS485]
Details Page 34
PTT [0–255] Details Page
34
PTTSIG [OFF, LOW, HI]
Details Page 34
PWR [20–37] Details Page
34
RESTORECONFIG Details
Page 34
RESTOREDEFAULTS
Details Page 34
RMODE [X710,
TRANSPARENT,
PACKET, CMAC, HELP]
Details Page 34
RSSI Details Page 34
RTSKEY [ON, OFF] Details
Page 35
RTU [ON/OFF/0-80] Details
Page 35
RX [xxx.xxxx] Details
Page 35
RXATTN [ON or OFF]
Details Page 35
RXLEVEL [–20 to 0]
Details Page 35
SD Series Reference Manual (x710 Mode)
Function
Configure radio for service within a P-20
Protected Network Chassis.
Ethernet interface configuration.
Key the radio (transmitter ON). This is generally a
radio test command.
Activates the radio's menu-based program (if
supported).
Shows configuration order entry string associated
with the radio. Programmed at the factory.
Shows an identifier string associated with the
radio's hardware bill of materials and revision.
Programmed at the factory.
Set the modem characteristics of the radio.
Set/display the owner's message.
Set/display the owner's name.
Set/display COM2 data port interface settings.
Set/display the Push-to-Talk delay in
milliseconds.
Set/display push-to-talk configuration.
Set/display the transmit power setting.
Restores a saved user configuration.
This command restores the original factory
configuration.
Allows the reconfiguration of the SD operating
mode.
Display the Received Signal Strength Indication.
Set/display how the radio responds to RTS
keying. Default is RTSKEY OFF, to prevent
undesired keying of the transmitter when RTS is
raised by a terminal program.
Re-enables or disables the radio's internal RTU
simulator and sets the RTU address.
Set/display receiver frequency.
Enables or disables receive attenuation.
Set/display the receive audio input level.
23