Table of Contents
Advertisement
Ethernet
Configuration
TX Key
Menu Activate
Model Number
Information
Analog/Digital
Modem Selection
MDS 05-4670A01, Rev. E
IPCONFIG
Ethernet interface configuration. This command is used to display or
change the configuration of the Ethernet interface. The command can be
used in several ways:
•
alone displays all current network settings.
IPCONFIG
•
IPCONFIG DHCP [ON/OFF]
static addressing.
•
IPCONFIG IP [ipaddr]
•
IPCONFIG NET [netmask]
subnet mask and gateway, respectively.
KEY
This command activates the transmitter. See also the
MENU
Activates the menu-based program within the transceiver (when sup-
ported), used for reprogramming the unit's firmware.
MODEL1
Displays the factory software configuration of the radio.
MODEL2
Displays the hardware configuration bill of material identifier.
See Table 11 on Page 21 for information on these pre-programmed
fields.
MODEM [xxxx]
This command selects the radio's modem characteristics. For digital
operation enter
MODEM xxxx
the radio. Table 12 shows the supported modem types.
NOTE:For compatibility with an existing MDS x710 system, make sure
to select the matching
Table 12. Modem Selection vs. Speed, Bandwidth & Sensitivity
Modem Type
Selection
1
Modem 9600
1, 2
Modem 4800
1, 3
Modem 3200
1, 2
Modem 9600M
SD Series Reference Manual (x710 Mode)
is used to switch between DHCP and
is used to set a static IP address.
and
IPCONFIG GW [Gateway]
, where
equals the modem selection of
xxxx
type. See Table 11.
MODEM
Over-the-air
B/W (kHz)
Speed (bps)
9600
12.5
4800
12.5
3200
5.00
9600
12.5
are used to set
command.
DKEY
Approximate
5
Sensitivity
-112 dBm
-112 dBm
-108 dBm
-106 dBm
31
Advertisement
Table of Contents
