Detailed Command Descriptions - GE DS-SD4-1 Reference Manual

24
Table 11. Command Summary (Continued)
Command name
RXTOL [NORMAL or
CUSTOM] Details Page
36
RXTOT [NONE, 1-1440]
Details Page 36
SAVECONFIG Details
Page 36
SCD [0-255] Details Page
36
SER Details Page 36
SHOW [DC, PWR] Details
Page 36
SNR Details Page 36
SPECTRUM [xxx.xx]
Details Page 37
SQUELCH [AUTO,
BYPASSED] Details
Page 37
SREV Details Page 37
STAT Details Page 38
SWC [ON, OFF] Details
Page 38
TFTP Details Page 38
TEMP Details Page 38
TOT [1-255, ON, OFF]
Details Page 39
TX [xxx.xxxx] Details Page
39
TXLEVEL [–20 to 0, AUTO]
Details Page 39
UNIT [10000...65000]
Details Page 39
UPTIME Details Page 39
VERSION Details Page 39

6.2 Detailed Command Descriptions

The only critical commands for most applications are transmit and
receive frequencies (
( ) settings. However, proper use of the additional commands
MODEM xxxx
allows you to tailor the transceiver for a specific use, or conduct basic
diagnostics on the radio. This section provides detailed information for
the user commands previously listed in Table 11 (Page 21).
SD Series Reference Manual (x710 Mode)
Function
Set/display the custom receive tolerance to
accommodate issues experienced with some
x790 masters.
Set/display the value of the receive time-out timer.
Saves a user configuration.
Set/display the Soft-Carrier Dekey delay in
milliseconds.
Display the radio serial number.
Display the DC voltages and transmit power level.
Signal-to-Noise Ratio, expressed in dB.
Display the transceiver's built-in spectrum
analyzer, where xxx.xx denotes center frequency.
Set/display analog squelch bypass.
Display the Software Revision Level.
Display radio status and alarms.
Switched Carrier configuration.
Set/display all TFTP settings.
Display the internal temperature of the radio in
degrees C.
Set/display the Time-out Timer delay in seconds.
Set/display the transmit frequency.
Set/display the transmit audio input level.
Set/display the transceiver's unit address.
Displays time since last system reboot.
Displays firmware package information.
TX xxx.xxxx, RX xxx.xxxx
) and Modem configuration
MDS 05-4670A01, Rev. E