Introduction; Conventions Used In This Manual - GE DS-SD4-1 Reference Manual

Software Notations
Model Number
Notations
Authorization
Features
MDS 05-4670A01, Rev. E

1.0 INTRODUCTION

This Reference Manual is one of two books provided for users of the
MDS SD Series Transceiver (Figure 1) operating in x710 Mode. It con-
tains an overview of common applications, installation planning data,
technical specifications, troubleshooting, and a listing of software com-
mands. This manual should be available to technical personnel who per-
form network design, configuration, and troubleshooting of the
equipment.
A companion Instruction Sheet is also available (Part no. 05-4669A01).
The scope of the Instruction Sheet is limited to installing the transceiver
and placing it in service for the first time.
Figure 1. MDS SD Series Transceiver

1.1 Conventions Used in This Manual

This product is designed for software control using a connected PC. To
indicate the names of software commands, keyboard entries, or other
information shown on a PC screen, a distinctive, bolded font is used as
follows:
Bolded font example (used for software commands and keyboard entries)
The term "SD" or "SD Series" is used in this manual to denote all
models in the SD product line. Specific model numbers such as "MDS
SD2" (216-235 MHz) "MDS SD4" (350-512 MHz) and MDS SD9
(928-960 MHz) are used only when necessary to reference model-spe-
cific features. This manual applies to all SD radios operating in x710
Mode.
Some features of the radio are dependent on purchased options and
applicable regulatory constraints. A "key" icon is shown near the
heading of these features in this manual. If your radio is not currently
authorized for a needed feature, contact your factory representative for
information on obtaining a new authorization code/key.
SD Series Reference Manual (x710 Mode)
Invisible place holder
1