Sending A Configuration - Honeywell Genesis Touch User Manual

Hide thumbs Also See for Genesis Touch:
Table of Contents

Advertisement

Configuring Monitors for Patients
Sending a Configuration
This section assumes that you are at the General Settings screen. Refer to Getting to the General Settings
Screen for more information. The password you will need is: 4237.
You have the ability to configure changes (including scheduling, questions, timing, etc.) for this patient at
the monitor and upload them to LifeStream. These changes will overwrite the configuration that currently
exists in LifeStream for this monitor. To send the configuration you have set up in the monitor to
LifeStream:
1. From the General Setting screen, select LifeStream. The LifeStream screen appears:
2. Select Send Configuration. Messages similar to the following appear in the window telling you the
status of communications:
3 - 24
© 2014 Honeywell HomMed. All rights reserved.
P4820EN.04
4/16/14

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hommed genesis touch

Table of Contents