Table of Contents
Advertisement
Patient Instructions
Before the monitoring session the patient should finish collecting test results, turn their glucose meter
off, and place their glucose meter next to the monitor before the monitoring session.
When it is time for the monitor to collect glucose test results, the monitor will prompt for the device. If
the monitor does not detect the device after the initial prompt, it will also prompt the patient to make
sure that the cable is connected to the com port programmed for the device. The monitor repeats both
prompts.
1.
Complete all tests and place the device next to the connector cable before the monitoring session.
Make sure the glucose meter is off.
2.
Genesis DM prompts:
"Please attach the glucose meter to the monitor. Be sure that the cable is attached to COM (1, 2 or A)."
3.
Plug the connector cable into the communication port on the meter.
4.
If using a model that requires that you manually turn it on, do so now.
The monitor collects the data and moves on to the next device or concludes the monitoring session.
P.4510EN.01
GENESIS DM CLINICAL GUIDE
12/5/2007
Patient Training
59
Advertisement
Table of Contents
