Honda EG3600CX Manual page 208

82Z30000.book 15 ページ ２０１０年６月２５日 金曜日 午後５時５０分
CRANKSHAFT BEARING
Drive out the radial ball bearing (1).
Apply oil to the circumference of a new bearing (2).
Drive the radial ball bearing until it is fully seated on the
end using the special tools.
EG3600CX/EG4000CX:
Except EG3600CX/EG4000CX:
CRANKSHAFT OIL SEAL
Remove the oil seal from the crankcase cover.
Apply grease to the lip of a new oil seal (1).
Drive the oil seal in the position as shown using the
special tools.
EG3600CX/EG4000CX:
Except EG3600CX/EG4000CX:
TOOLS:
Attachment, 62 × 68 mm (3)
Pilot, 30 mm (4)
Driver (5)
TOOLS:
Attachment, 72 × 75 mm (3)
Pilot, 35 mm (4)
Driver (5)
TOOLS:
Attachment, 45 × 50 mm (2)
Driver (3)
TOOLS:
Attachment, 52 × 55 mm (2)
Driver (3)
07746-0010500
07746-0040700
07749-0010000
07746-0010600
07746-0040800
07749-0010000
(5)
(3)
(circumference)
07946-6920100
07749-0010000
2 mm (0.08 in)
07746-0010400
OIL SEAL RIP
07749-0010000
CYLINDER BLOCK
(1)
(4)
(3)
(2)
14-15
(2)
(1)