Honda EG3600CX Manual page 185

82Z30000.book 4 ページ ２０１０年６月２５日 金曜日 午後５時５０分
CYLINDER HEAD
CYLINDER HEAD DISASSEMBLY/ASSEMBLY
Remove the cylinder head (page 13-3).
INTAKE/EXHAUST VALVE SPRING RETAINER
DISASSEMBLY:
Push down and slide the valve spring retainer
to the side so that the valve stem slips through
the hole at the side of the valve spring
retainer.
Do not remove the valve spring retainer while
the cylinder head is installed to the cylinder
barrel, or the valve will drop into the cylinder.
VALVE SPRING SEAT
VALVE
GUIDE CLIP
VALVE ROTATOR
PIVOT ADJUSTING
NUT (2)
10 N·m
(1.0 kgf·m, 7 lbf·ft)
ROCKER ARM
PIVOT (2)
(Apply to the
threads and pivot)
NOTE 1 Valve guide replacement
13-4
SPARK PLUG
18 N·m (1.8 kgf·m, 13 lbf·ft)
EXHAUST VALVE
GUIDE (NOTE 1)
VALVE STEM SEAL
VALVE SPRING (2)
PUSH ROD
PUSH ROD (2)
GUIDE PLATE
ASSEMBLY:
Before installing the push rods, check the ends of the push
rods for wear.
PIVOT BOLT (2)
24 N·m
Be sure the ends of the push rods are firmly seated in the
(2.4 kgf·m, 18 lbf·ft) valve lifters.
VALVE ROCKER ARM
ASSEMBLY:
Before installing the rocker arm, check for wear on the surfaces of the
rocker arm that contact the pivot bolt, push rod, and valve stem.
CYLINDER HEAD
INTAKE VALVE GUIDE (NOTE 1)
BOLT (CT) (6 x 12 mm)
(Apply to the tappet
surface and pivot)
EXHAUST VALVE
ASSEMBLY:
Do not interchange
with the intake valve.
The exhaust valve is
smaller than the
intake valve.
INTAKE VALVE
ASSEMBLY:
Do not interchange
with the exhaust
valve.
The intake valve is
larger than the
exhaust valve.
SHROUD
See page 13-8