Honda EG3600CX Manual page 130

82Z30000.book 19 ページ ２０１０年６月２５日 金曜日 午後５時５０分
If the specified voltage is not obtained, stop the engine
and disconnect the exciter winding 3P connector (1).
Measure the resistance between the exciter winding 3P
connector
No.3 (Blue) terminal.
If the specified resistance is zero or infinity, replace the
stator.
POWER COIL INSPECTION
Remove the harness clip base bolts (page 8-5).
Disconnect the power coil 2P connector
Measure the resistance between the connector
terminals of the power coil side.
Resistance:
BRUSH HOLDER INSPECTION
CONTINUITY INSPECTION
Remove the brush holder (page 7-11).
Check for continuity between the each brush tip (1) and
wire terminal (2).
There should be no continuity.
stator side No.1 (Blue) terminal and
Resistance (Ω)
Type
(at 20 °C/68 °F)
EG3600 (UH type)
EG4000 (MH, RH, KH,
RHH type)
EG4000 (LDH type)
EG4500 (UH, RGH type)
EG5000 (MH, RH, KH,
RHH type)
EG5000
(SKH, SH, LDH type)
EG5500 (UH, RGH type)
EG6500 (MH, RH, KH,
RHH type)
EG6500
(SKH, SH, LDH, LTH
type)
0.8 – 1.2 Ω
GENERATOR/CHARGING SYSTEM
1.5
1.3
1.2
1.1
1.1
1.0
.
(1)
(2)
7-19