82Z30000.book 6 ページ 2010年6月25日 金曜日 午後5時50分
FUEL SYSTEM
CARBURETOR REMOVAL/INSTALLATION
Gasoline is highly flammable and explosive. You
can be burned or seriously injured when handling
fuel.
• Keep heat, sparks and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
Remove the air cleaner base (page 5-5).
Disconnect the fuel cut solenoid wire connectors (page 2-10).
GOVERNOR ROD/THROTTLE RETURN SPRING
REMOVAL/INSTALLATION:
Remove the carburetor to a point where the groove
of throttle arm lines up with the governor rod, and
then lift the governor rod out of the hole of throttle
arm and unhook the throttle return spring.
Installation is in the reverse order of removal.
GOVERNOR ROD
THROTTLE
RETURN
SPRING
CHOKE DIAPHRAGM
CARBURETOR
AIR CLEANER
PACKING
5-6
EG3600/EG4000: TUBE (3.5 x 65 mm)
EG4500/EG5000/EG5500/EG6500: TUBE (3.5 x 75 mm)
DASH ROT CHECK VALVE
INSTALLATION:
Connect the black end of the dash
pot to the diaphragm tube.
CARBURETOR
INSULATOR
INSULATOR
CARBURETOR
PACKING
PACKING
DIAPHRAGM TUBE
TUBE CLAMP
FUEL CUT SOLENOID HARNESS WIRE