Honda EG3600CX Manual page 205

82Z30000.book 12 ページ ２０１０年６月２５日 金曜日 午後５時５０分
CYLINDER BLOCK
Remove the connecting rod and measure the
plastigauge.
STANDARD:
SERVICE LIMIT:
If the clearance is more than the service limit, inspect
the following:
• Connecting rod big end I.D. (page 14-11)
• Crank pin O.D. (page 14-12)
If the part that is not within the service limit replaces a
new one, reinspect the clearance.
CRANK PIN O.D.
Measure the crank pin O.D. of the crankshaft.
EG3600CX/EG4000CX:
STANDARD:
SERVICE LIMIT:
Except EG3600CX/EG4000CX:
STANDARD:
SERVICE LIMIT:
If the measurement is less than the service limit,
replace the crankshaft (page 14-4).
CRANKSHAFT RUNOUT
Remove the crankshaft bearing (page 14-18).
Set the crankshaft on V-blocks and measure the runout
using a dial indicator.
SERVICE LIMIT:
If the measured runout is more than the service limit,
replace the crankshaft (page 14-4).
CAMSHAFT O.D.
Measure the camshaft O.D. of the camshaft.
STANDARD:
SERVICE LIMIT:
If the measurement is less than the service limit,
replace the camshaft (page 14-4).
14-12
0.040 – 0.064 mm
(0.0016 – 0.0025 in)
0.12 mm (0.005 in)
32.975 – 32.985 mm
(1.2982 – 1.2986 in)
32.92 mm (1.296 in)
35.975 – 35.985 mm
(1.4163 – 1.4167 in)
35.93 mm (1.415 in)
0.1 mm (0.004 in)
15.966 – 15.984 mm
(0.6286 – 0.6293 in)
15.92 mm (0.627 in)
PLASTIGAUGE
PLASTIGAUGE
SCALE
16 mm
(0.6 in)
16 mm
(0.6 in)