Honda EG3600CX Manual page 152

82Z30000.book 11 ページ ２０１０年６月２５日 金曜日 午後５時５０分
STARTER MOTOR INSPECTION (CXS
TYPE ONLY)
STARTER SOLENOID
Connect the positive (+) lead of a 12V battery to the
solenoid terminal (1) and the negative (-) lead to the
solenoid body. Measure the resistance between the
battery and starter motor terminals as shown.
Continuity should exist when the battery is connected
and not exist when the battery is disconnected.
BRUSH LENGTH
Measure the brush length.
If the negative brush length is less than the service limit,
replace the brush and brush holder.
If the positive brush length is less than the service limit,
replace the center bracket and brush holder.
STANDARD:
SERVICE LIMIT: 3.5 mm (0.14 in)
BRUSH CONTINUITY CHECK
Check for continuity between the positive (+) brushes
(1) and negative (-) brushes (2).
There should be continuity between both the positive
brushes.
There should be continuity between both the negative
brushes.
There should be no continuity from either positive brush
to either negative brush.
If the correct continuity of the positive (+) brushes is not
obtained, replace the center bracket (page 9-10).
If the correct continuity of the negative (-) brushes is not
obtain, replace the negative (-) brushes.
7.0 mm (0.28 in)
STARTING SYSTEM
(1)
(2)
(1)
(1)
(2)
9-11