Honda EG3600CX Manual page 148

82Z30000.book 7 ページ ２０１０年６月２５日 金曜日 午後５時５０分
Apply grease to the two ratchets (1).
Install the two ratchets and the two ratchet springs (2)
to the recoil starter pulley as shown.
Apply grease to the inside of the spring retainer (1).
Set the friction spring (2) and friction plate (3), spring
retainer to the recoil starter pulley in the direction as
shown.
Hold the spring retainer and tighten the center screw to
the specified torque.
TORQUE: 5.4 N·m (0.55 kgf·m, 4.0 lbf·ft)
Turn the recoil starter pulley (1) more than 2 turns
counterclockwise to preload the starter return spring.
Be sure to hold the recoil starter pulley.
Pass the recoil starter rope (1) through hole (2) of the
recoil starter case (3), and tie a temporary knot in the
middle of the recoil starter rope as shown.
Check the recoil starter operation (page 9-8).
STARTING SYSTEM
(2)
(4)
(1)
(3)
(2)
(1)
(2)
(1)
(1)
(3)
9-7