Cylinder Block Inspection - Honda EG3600CX Manual

82Z30000.book 7 ページ ２０１０年６月２５日 金曜日 午後５時５０分

CYLINDER BLOCK INSPECTION

CAM SHAFT HOLDER I.D.
CRANKCASE COVER SIDE
Measure the camshaft holder I.D. of the crankcase
cover.
STANDARD:
SERVICE LIMIT: 16.05 mm (0.632 in)
If the measurement is more than the service limit,
replace the crankcase cover (page 14-3).
Inspect the camshaft O.D. (page 14-12) with this
inspection.
CYLINDER BARREL SIDE
Measure the camshaft holder I.D. of the cylinder barrel.
STANDARD:
SERVICE LIMIT:
If the measurement is more than the service limit,
replace the cylinder barrel (page 14-4).
Inspect the camshaft O.D. (page 14-12) with this
inspection.
CYLINDER SLEEVE I.D.
Measure and record the cylinder I.D. at three levels in
both the "X" axis (perpendicular to crankshaft) and the
"Y" axis (parallel to crankshaft). Take the maximum
reading to determine cylinder wear and taper.
EG3600CX/EG4000CX:
EG4500CX/EG5000CX:
EG5500CX/EG6500CX/EG5500CXS/EG6500CXS:
If the measurement is more than the service limit,
replace the cylinder barrel (page 14-4).
Inspect the piston skirt O.D. (page 14-8) with this
inspection.
16.000 – 16.018 mm
(0.6299 – 0.6306 in)
16.000 – 16.018 mm
(0.6299 – 0.6306 in)
16.05 mm (0.632 in)
STANDARD: 77.000 – 77.017 mm
(3.0315 – 3.0322 in)
SERVICE LIMIT: 77.17 mm (3.038 in)
STANDARD: 82.000 – 82.017 mm
(3.2283 – 3.2290 in)
SERVICE LIMIT: 82.17 mm (3.235 in)
STANDARD: 88.000 – 88.017 mm
(3.4646 – 3.4652 in)
SERVICE LIMIT: 88.17 mm (3.471 in)
CYLINDER BLOCK
X
Y
TOP
MIDDLE
BOTTOM
14-7