Honda EG3600CX Manual page 124

82Z30000.book 13 ページ ２０１０年６月２５日 金曜日 午後５時５０分
GENERATOR DISASSEMBLY/ASSEMBLY
Remove the generator (page 7-11).
TAPPING SCREW
(5 x 14 mm) (2)
LDH/LTH type:
SPRING WASHER (5 mm) (4)
Except LDH/LTH type:
SPRING WASHER (5 mm) (2)
LDH/LTH type:
NUT (5 mm) (4)
Except LDH/LTH type:
NUT (5 mm) (2)
DC DIODE
REAR HOUSING
TAPPING SCREW
(5 x 12 mm)
ROTOR BEARING (6204)
REMOVAL:
Be careful not to
damage the slip rings.
Avoid contact with the
slip ring area while
bearing removal and
installation.
When replacing the
bearing, always use a
new bearing with clip.
LDH/LTH type:
WASHER (5 mm) (4)
Except LDH/LTH type:
AC OUTPUT
WASHER (5 mm) (2)
TERMINAL
INSTALLATION:
Install the bearing with the grooved end
towards the rotor, using a special tools.
Driver, 22 mm I.D.
07746-0020100
Driver attachment, 20 mm I.D.
07746-0020400
BEARING
ROTOR
GENERATOR/CHARGING SYSTEM
LDH/LTH type:
BOLT (5 x 20 mm) (4)
Except LDH/LTH type:
BOLT (5 x 20 mm) (2)
STATOR
GENERATOR
COOLING FAN
5 N·m (0.51 kgf·m, 3.7 lbf·ft)
ROTOR
ASSEMBLY:
Make sure there is no
obstruction on the magnets.
Install the bearing clip in the bearing groove, so the
gap is at the shallow part of the groove, and the
raised area of the clip is centered in the deepest part
of the groove.
BEARING
CLIP
BEARING
STATOR COVER
TAPPING SCREW
(5 x 14 mm) (3)
BEARING
CLIP
groove
(deep side)
groove
(shallow side)
7-13