Honda EG3600CX Manual page 151

82Z30000.book 10 ページ ２０１０年６月２５日 金曜日 午後５時５０分
STARTING SYSTEM
STARTER MOTOR DISASSEMBLY/ASSEMBLY (CXS TYPE ONLY)
Remove the starter motor (page 9-9).
HOUSING
ASSEMBLY:
Make sure there is no
obstruction on the magnets.
SCREW
(5 x 32 mm) (3)
SCREW
(5 x 14 mm) (2)
STARTER
SOLENOID
NUT SCREW
(5 x 32 mm)
(6 mm)
STARTER
CENTER BRACKET
SOLENOID WIRE
OVERRUNNING CLUTCH/PINION GEAR
9-10
BRUSH HOLDER
ASSEMBLY:
Install the insulator, brush holder,
negative brush terminals, and
two screws to the center bracket
as shown.
Install the brush springs and
brushes, and push the brushes in
the holders with a suitable wire
so that they do not interfere with
the commutator.
ARMATURE
SNAP RING
POSITIVE
BRUSH (2)
SCREW
REDUCTION
(4 x 6 mm)
GEAR
WASHER
BRUSH HOLDER
SCREW (2)
NEGATIVE
BRUSH (2)
INSULATOR
POSITIVE
BRUSH (2)
SUITABLE
BRUSH
WIRE
SPRING (4)
CENTER
BRACKET
BRUSH
BRUSH
SPRING (4)
SCREW
(4 x 14 mm) (2)
NEGATIVE
BRUSH (2)
DRIVE PINION
GEAR
DRIVE SIDE
HOUSING
INSULATOR
INSPECTION:
Check for cracks
or damage.
GASKET