Honda EG3600CX Manual page 123

82Z30000.book 12 ページ ２０１０年６月２５日 金曜日 午後５時５０分
GENERATOR/CHARGING SYSTEM
GENERATOR INSTALLATION
Rotate the crankshaft and align the
starter pulley with the hole (2) of recoil starter case.
Make sure the piston is at top dead center on the
compression stroke.
Install two dowel pins (3) and front housing (4).
Install and tighten four bolts (5).
TORQUE: 24 N·m (2.4 kgf·m, 18 lbf·ft)
Degrease the tapered surface of the rotor and
crankshaft.
Install the rotor (6) to crankshaft by aligning magnet (7)
of rotor and rib (8) of front housing.
Install and tighten bolt (9) to the specified torque.
TORQUE: 44 N·m (4.5 kgf·m, 32 lbf·ft)
Install the stator to the engine by aligning the ribs (1) for
welding and
Install the rear housing (3).
Install and tighten four bolts (4) to the specified torque
in a crisscross pattern.
TORQUE: 9.8 N·m (1.00 kgf·m, 7.2 lbf·ft)
After rear housing installation, check the following:
• There is not clearance between the front housing
and stator cover (5).
• Rotor turns around smoothly by pulling the recoil
rope.
Install the brush holder (6) and tighten the screw (7).
Install the AC output terminal (8) and tighten the bolt
(9).
7-12
mark (1) on the
marks (2) of front housing.
(1)
(3)
(4)
(5)
(8)
(2)
(6) (8)
(7)
(9)
(4)
(2)
(6)
(9)
(7)
(5)
(1)
(3)