Honda EG3600CX Manual page 122

82Z30000.book 11 ページ ２０１０年６月２５日 金曜日 午後５時５０分
GENERATOR REMOVAL
Remove the engine (page 12-2).
BRUSH HOLDER
Before rear housing removal,
remove the brush holder.
TAPPING SCREW
(5 x 18 mm)
REAR HOUSING
EG3600CX/EG4000CX:
BOLT (6 x 113 mm) (4)
EG4500CX/EG5000CX:
BOLT (6 x 147 mm) (4)
EG5500CX/EG6500CX/
EG5500CXS/EG6500CXS:
BOLT (6 x 160 mm) (4)
EG3600CX/EG4000CX:
BOLT (10 x 203 mm)
EG4500CX/EG5000CX:
BOLT (10 x 237 mm)
EG5500CX/EG6500CX/
EG5500CXS/EG6500CXS:
BOLT (10 x 250 mm)
WASHER
ROTOR
To prevent the rotor from dropping when removed using the special
tool, place a wooden block and rag underneath the rotor or support with
your hand.
STATOR
TAPPING SCREW
(5 x 14 mm) (2)
REMOVER
WEIGHT
07741-0010201
GENERATOR/CHARGING SYSTEM
FRONT HOUSING
DOWEL PIN (8 x 12 mm) (2)
ROTOR
SLIDING SHAFT
07736-0010101
WOODEN BLOCK
BOLT (8 x 60 mm) (4)
RAG
7-11