Piston Disassembly/Assembly - Honda EG3600CX Manual

82Z30000.book 6 ページ ２０１０年６月２５日 金曜日 午後５時５０分
CYLINDER BLOCK

PISTON DISASSEMBLY/ASSEMBLY

Remove the piston(page 14-4).
PISTON RING SET
ASSEMBLY:
Be sure that the top ring and second ring are
not interchanged.
Install the top ring and second ring on the
piston with the maker mark side facing up.
Check that the piston rings rotate smoothly
after installing them.
Space the piston ring end gaps 120 degrees
apart, and do not align the ring end gaps with
the piston pin bore.
PISTON
SECOND RING
PISTON PIN
PISTON PIN CLIP (2)
ASSEMBLY:
Install by setting one end of the piston pin
clip in the groove of the piston pin bore,
holding the other end with long needle
pliers, and rotating the clip in.
Do not align the end gap of the piston pin
clip with the cutout of the piston pin bore.
PISTON PIN CLIP
CUTOUT
14-6
MAKER MARK
TOP RING
OIL RING
END GAP
LONG END
TOP RING
120°
SECOND RING
120°
120°
SIDE RAIL
10 mm (0.4 in)
SPACER
SIDE RAIL
10 mm (0.4 in)
PISTON
CONNECTING ROD UPPER
ASSEMBLY:
Set the connecting rod upper with
the long end toward the mark on
the piston head.
OIL RING
(COMBINATION
RING)
MARK