Configuring A Standalone Auxiliary Control Unit - Cisco TelePresence System 1000 Hardware Options & Upgrade Manual

Auxiliary Control Unit
Step 3 Plug the jumper cords for the lights and the projector serial cable into the auxiliary control unit.
Figure 3-3 Cable Routing for Auxiliary Control Unit
Power
Projector
RJ45 Ethernet
If you encounter clearance problems when you connect the serial cable to the projector, remove the
Note
projector from the table by completing the steps in the "Replacing the Projector" section in the
"Field-Replaceable Unit Guide" chapter of the
and Field Replacement Unit

Configuring a Standalone Auxiliary Control Unit

To configure your audio extension unit with your CTS-3000, refer to
Administrator's Guide
Cisco TelePresence System
3-4
1 2
SERIA L PO RTS RES ET
Auxiliary Control Unit
Cisco TelePresence System 3000 Assembly, Use & Care,
Guide.
for your software release.
Chapter 3 Options for the Cisco TelePresence System 3000
1 2
10/ 100 NETWORK PO RTS
Primary Codec
Cisco TelePresence System
OL-16441-01