Cisco TelePresence System 1000 Hardware Options & Upgrade Manual page 52

Cisco TelePresence Presentation Codec
Step 16 Route the signal cables for the presentation codec using one of the following diagrams:
•
If you have an Auxiliary Control Unit, substitute the signal cabling between the presentation codec and
Note
the primary codec with the alternate cabling for the Auxiliary Control Unit.
Figure 3-12 Cable Routing for Presentation Codec and Auxiliary Control Unit
Projector
Serial Video In
Presentation Codec
Primary Codec Signal
Auxiliary Video In
Center Left Right
Microphone
Speaker
Cisco TelePresence System
3-14
For a standard CTS-3000 installation, use the following wiring diagram for the presentation codec.
Video out
Auxilliary
Chapter 3
Auxiliary Control Unit (Optional)
Left Codec
Right Codec
Camera
Primary
Codec
Document Camera
Signal
IP Phone
Network
Options for the Cisco TelePresence System 3000
1 2
SERIA L PO RTS RES ET
Serial 2
Serial 1
Ethernet 1
Ethernet 2
Primary Codec
Auxiliary Video In
Display
Auxiliary Video Out
1 2
10/ 100 NETWORK PO RTS
OL-16441-01