Configuring A Cisco Telepresence Presentation Codec - Cisco TelePresence System 1000 Hardware Options & Upgrade Manual

Chapter 4 Options for the Cisco TelePresence System 3200
Step 21 Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
window) is Enabled/Up.
Step 22 Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working
properly.
Step 23 Navigate to the Device Information > Configuration > CUCM settings window, then perform the
following actions:
a.
b.
If you encounter problems, you might have to reboot your presentation codec several times before it
Note
becomes active. To reboot the presentation codec, turn off and on the PDU where you plugged in the
presentation codec.

Configuring a Cisco TelePresence Presentation Codec

To configure your audio extension unit with your CTS-3000, refer to
Administrator's Guide
OL-16441-01
In the Certificate Trust List (CTL) area, delete the Certificate Trust List (CTL) from your system by
clicking Delete CTL.
In the Use Configuration TFTP Server area, click Automatic to set TFTP conditions to their default
value and remove any alternate TFTP servers.
for your software release.
Cisco TelePresence Presentation Codec
Cisco TelePresence System
Cisco TelePresence System
4-13