Configuring A Cisco Telepresence Presentation Codec - Cisco TelePresence System 1000 Hardware Options & Upgrade Manual

Hide thumbs Also See for TelePresence System 1000:
Table of Contents

Advertisement

Chapter 3
Options for the Cisco TelePresence System 3000
Step 21
Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
window) is Enabled/Up.
Step 22
Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working
properly.
Step 23
Navigate to the Device Information > Configuration > CUCM settings window, then perform the
following actions:
a.
b.
If you encounter problems, you might have to reboot your presentation codec several times before it
Note
becomes active. To reboot the presentation codec, turn off and on the PDU where you plugged in the
presentation codec.

Configuring a Cisco TelePresence Presentation Codec

To configure your audio extension unit with your CTS-3000, refer to
Administrator's Guide
Adding a Cisco TelePresence Presentation Codec with a Auxiliary Control Unit
If your system includes a auxiliary control unit to a CTS-3000, add a presentation codec by following
the steps in the
section on page 3-5
See
OL-16441-01
In the Certificate Trust List (CTL) area, delete the Certificate Trust List (CTL) from your system by
clicking Delete CTL.
In the Use Configuration TFTP Server area, click Automatic to set TFTP conditions to their default
value and remove any alternate TFTP servers.
for your software release.
"Adding a Standalone Cisco TelePresence Presentation Codec to a Primary Codec"
and perform the following additional cabling steps:
Connect the Primary Codec Document Camera Ethernet connection (orange Ethernet connection on
the primary codec) to one Ethernet port of the auxiliary control unit.
Connect the other Ethernet port of the auxiliary control unit to the Presentation Codec Ethernet port
(white/red Ethernet connection on the presentation codec).
Connect a serial cable between the serial port of the projector and the Serial 1 port of the auxiliary
control unit.
Figure 3-13
for more information.
Cisco TelePresence Presentation Codec
Cisco TelePresence System
Cisco TelePresence System
3-17

Advertisement

Table of Contents
loading

Table of Contents