Adding A Standalone Presentation Codec - Cisco TelePresence System 1000 Hardware Options & Upgrade Manual

Cisco TelePresence Presentation Codec
Key Part Description
7
Right end cap
8 M4 x 6mm flat head screws
9 M5 x 12mm hex head screws
10 M4 x 10mm pan head screws

Adding a Standalone Presentation Codec

To add the Cisco TelePresence Presentation Codec to the CTS-1000, complete the following procedure:
Procedure
Power off the system by performing the following steps:
Step 1
a.
b.
c.
d.
e.
Note
f.
g.
h.
i.
Cisco TelePresence System
1-4
Get the IP address for the system codec as follows:
On the IP phone, locate Manual at the bottom of the screen and press the Manual soft key.
1.
If you cannot locate the Manual soft key, continue to Step
Note
Locate Info at the bottom of the screen and press the Info soft key.
2.
Scroll down to the IP Address listing and copy the address.
3.
Open a browser on a computer that is connected to the network.
In the URL field, type the IP address for the system codec and press Enter. The browser launches
the Cisco TelePresence System Administrator.
In the Admin field, type admin.
In the Password field, type cisco.
If your administrator has changed the user name or password, enter those values.
Click Login.
Locate the Phone pane in the upper left-hand corner of the administrator page and select
Troubleshooting > System Reset. the Restart Cisco TelePresence System button appears at the top
of the window.
Click the Restart Cisco TelePresence System button to start the reset.
The monitor goes dark and, the encircled numbers one through six appear at the bottom of the
display screen on the left-hand side.
After the first number changes to a check mark, unplug the system power cord from the wall socket.
Chapter 1
Part Number Qty
700-27344-01 1
48-0448-01 4
48-1936-01 4
48-1948-01 4
Options for the Cisco TelePresence System 500
Notes
2.
OL-16441-01