Cisco TelePresence System 1000 Hardware Options & Upgrade Manual page 139

Chapter 5 Upgrading a Cisco TelePresence System 3000 to a Cisco TelePresence System 3200
Tip Before plugging the Light fixture power cables into the unit, label each one. For example, 5' Left light,
4' Right light.
Attach and route the power-over-Ethernet and HDMI cables for the camera.
Step 7
Figure 5-59 Cabling the Camera Assembly
5
RJ45 Power over Ethernet
10 HDMI connector
Note The camera cluster can experience radio frequency interference issues if the camera Ethernet and
HD video cables are routed, bundled, or tied together. Cisco recommends that you route the Ethernet and
HD video cables separately and use cable ties to tie them to opposite sides of the frame. In addition,
attach the ferrite core and use tie wraps to secure them as shown in
OL-16441-01
14
15
Attaching and Routing Cables
Figure 5-59.
Cisco TelePresence System
5-69