Adding An Auxiliary Control Unit With A Cisco Telepresence Presentation Codec; Configuring An Auxiliary Control Unit; Cisco Telepresence Presentation Codec - Cisco TelePresence System Series Hardware Upgrade Manual

Chapter 3 Options for the Cisco TelePresence System 1000
Step 7 Route the cables for the auxiliary control unit by completing the following steps:
a.
b.
Note
Mount the front panel onto the frame by completing the following steps:
Step 8
a.
b.
c.
Power on the system by plugging the power cord into an active wall socket.
Step 9
Adding an Auxiliary Control Unit with a Cisco TelePresence Presentation
Codec
To add an auxiliary control unit to a CTS 1000 with a presentation codec, complete the steps in the
"Adding an Auxiliary Control Unit" section on page 3-2
•
•

Configuring an Auxiliary Control Unit

To configure the presentation codec, refer to
software release.

Cisco TelePresence Presentation Codec

The Cisco TelePresence Presentation Codec (CTS-HFR-COLLAB) provides 30 frames per second (fps)
capabilities to support full-motion video presentations between Cisco TelePresence endpoints when
used with an auxiliary presentation display.
You must install an auxiliary display to enable the 30 fps feature. For the list of the auxiliary displays
Note
that are supported for use with Cisco TelePresence systems, refer to the
Cisco TelePresence System
connects auxiliary devices to the codec.
OL-16441-01
Plug the power cord for the auxiliary control unit into a power outlet.
Plug the power cord for the light fixture into any of the switched outlets of the auxiliary control unit.
Do not plug the light fixture into the outlet marked "UNSWITCHED."
Place the front panel onto the frame.
Using a #3 Phillips screwdriver, attach the six screws next to the speaker.
Mount the black speaker grille onto the front panel.
Connect the Primary Codec Document Camera Ethernet connection (orange Ethernet connection on
the primary codec) to one Ethernet port of the auxiliary control unit.
Connect the other Ethernet port of the auxiliary control unit to the Presentation Codec Ethernet port
(white/red Ethernet connection on the presentation codec).
for your software release. Note that Cisco does not supply the cable that
Cisco TelePresence Presentation Codec
and add the following additional connections:
Cisco TelePresence System Administrator's Guide
Cisco TelePresence System
for your
Release Notes for
3-5