Chapter 1
Options for the Cisco TelePresence System 500
Step 11
Attach the end caps to the presentation codec assembly.
Tighten the screws until they are snug but do not overtighten.
Note
Figure 1-11
Right End Cap
Power on the CTS-500 system.
Step 12
Note
You might have to reboot your presentation codec several times before it becomes active. For
information about rebooting the CTS-500, refer to the
Instructions"
Guide.
Adding a Cisco TelePresence Presentation Codec with a Auxiliary Control Unit
To add a presentation codec to an CTS-500 with an auxiliary control unit, complete the steps in the
"Adding a Standalone Presentation Codec" section on page 1-4
cabling steps:
•
OL-16441-01
chapter of the
Cisco TelePresence 500 Assembly, Use & Care, and Field-Replacement Unit
Connect the Primary Codec Document Camera Ethernet connection (orange Ethernet connection on
the primary codec) to one Ethernet port of the auxiliary control unit.
Cisco TelePresence Presentation Codec
9
9
7
10
"Field-Replacement and Upgrade Disassembly
and perform the following additional
Cisco TelePresence System
10
1-13