Adding An Auxiliary Control Unit - Cisco TelePresence System Series Hardware Upgrade Manual
Hide thumbs
Also See for TelePresence System Series:
- User manual (51 pages) ,
- Quick reference manual (2 pages) ,
- Getting started manual (41 pages)
Table of Contents
Advertisement
Chapter 6
Options for the Cisco TelePresence System 3000, 3010, 3200, and 3210
Adding an Auxiliary Control Unit
The following illustrations and steps describe how to attach the auxiliary control unit to your
Cisco TelePresence system.
Turn off the power to the side PDUs and unplug the power cables for the lighting assembly.
Step 1
Figure 6-1
PDU Location and Lighting Assembly Cable Routing
Power
Note
Your installation might differ from this diagram. There might be one PDU on the left side of the display
structure, rather than two; in addition, there might be a PDU in the center rear of the display structure.
The terms left and right refer to the system as you face it from the front.
Note
OL-16441-01
Auxiliary Control Unit
Cisco TelePresence System
6-3
Advertisement
Table of Contents
