Chapter 3
Options for the Cisco TelePresence System 1000
Step 20
Attach the end caps to the presentation codec assembly.
Tighten the screws until they are snug but do not overtighten.
Note
Figure 3-13
Right End Cap
9
9
Power on the CTS 1000 system.
Step 21
You might have to reboot your presentation codec several times before it becomes active. For
Note
information about rebooting the CTS 1000, refer to the
Instructions"
Unit
Adding a Cisco TelePresence Presentation Codec with a Auxiliary Control Unit
To add a presentation codec to an CTS 1000 with an auxiliary control unit, complete the steps in the
"Adding a Presentation Codec" section on page 3-6
OL-16441-01
chapter of the
Cisco TelePresence 1000 Assembly, Use & Care, and Field-Replacement
Guide.
Cisco TelePresence Presentation Codec
9
9
7
10
"Field-Replacement and Upgrade Disassembly
and perform the following additional cabling steps:
Cisco TelePresence System
10
3-17