Configuring A Cisco Telepresence Presentation Codec; Adding A Cisco Telepresence Presentation Codec With A Auxiliary Control Unit - Cisco TelePresence System Series Hardware Upgrade Manual

Cisco TelePresence Presentation Codec
When you use the audio/video extension unit as a video splitter, connect port 1 of the "Video in"
Note
connection from the presentation codec, and port 4 of the "Video out" connection to the projector.
Step 6 Replace the primary codec and reattach it to the display stand.
If you removed the cables from the primary codec, recable the codec using the diagram in
Step 7
or Figure
Step 8 Continue to the
configure your system in Cisco Unified Communications Manager for use with a presentation codec.

Configuring a Cisco TelePresence Presentation Codec

To configure the presentation codec with the Cisco TelePresence system, complete the following steps.
Log in to the Cisco Unified Communications Manager web GUI.
Step 1
Navigate to Device > Phone.
Step 2
Find the Cisco Unified IP Phone that controls your Cisco TelePresence system by clicking Find.
Step 3
Click the hypertext link next to the phone that controls your Cisco TelePresence System to select it.
Step 4
In the Optional Hardware area, click the Presentation Codec check box.
Step 5
Figure 6-19 Presentation Codec Check Box
The options that display in this area might differ from what you see in your system.
Note
Click Save, then, click Apply Config to apply the configuration to your system.
Step 6

Adding a Cisco TelePresence Presentation Codec with a Auxiliary Control Unit

If your system includes a auxiliary control unit to a Cisco TelePresence system, add a presentation codec
by following the steps in the
System 3000 and 3200" section on page 6-7
•
Cisco TelePresence System
6-24
6-18.
"Configuring a Cisco TelePresence Presentation Codec" section on page 6-24
"Adding a Cisco TelePresence Presentation Codec—Cisco TelePresence
Connect the Primary Codec Document Camera Ethernet connection (orange Ethernet connection on
the primary codec) to one Ethernet port of the auxiliary control unit.
Chapter 6 Options for the Cisco TelePresence System 3000, 3010, 3200, and 3210
and perform the following additional cabling steps:
Figure 6-17
to
OL-16441-01