Cisco TelePresence System Series Hardware Upgrade Manual page 42

Cisco TelePresence Presentation Codec
Figure 3-10
display. You use the display for shared presentations. Connect the presentation source to the codec using
the DVI-to-VGA cable; plug the DVI connection into the Auxiliary Video In connection.
To prevent the codec powering off after a meeting, do not plug the presentation codec power cord into
Caution
any of the Switched outlets in the auxiliary control unit. Plug the codec into either the PDU, an electrical
outlet, or the single outlet on the auxiliary control unit that is marked "UNSWITCHED".
If your CTS 1000 does not have an auxiliary control unit, route the Ethernet cables for the Primary Codec
Note
signal directly between the codec and presentation codec, and omit the DVI-to-Serial connection
between the external presentation display and the auxiliary control unit.
Figure 3-10 Cabling Diagram—CTS 1000 with Presentation Codec and External Presentation Display
External
Presentation Display
Video In
Presentation Codec
Auxiliary Video In
Video out
Microphone
Speaker
Other Possible Configuration
Cisco TelePresence System
3-14
shows you the cabling diagram for a CTS 1000 with a presentation codec and an external
Camera
Auxiliary
Network
Document Camera
Port
IP Phone
Network
Chapter 3 Options for the Cisco TelePresence System 1000
Codec
Auxiliary Video In
Display
Auxiliary Video Out
OL-16441-01