Cisco TelePresence System Series Hardware Upgrade Manual page 160

Upgrading a CTS 3000 to a CTS 3200
Tip Before plugging the Light fixture power cables into the unit, label each one. For example, 5' Left light,
4' Right light.
Attach and route the power-over-Ethernet and HDMI cables for the camera.
Step 7
Figure 6-79 Cabling the Camera Assembly
5
RJ45 Power over Ethernet
10 HDMI connector
The camera cluster can experience radio frequency interference issues if the camera Ethernet and
Note
HD video cables are routed, bundled, or tied together. Cisco recommends that you route the Ethernet and
HD video cables separately and use cable ties to tie them to opposite sides of the frame. In addition,
attach the ferrite core and use tie wraps to secure them as shown in
Cisco TelePresence System
6-94
Chapter 6 Options for the Cisco TelePresence System 3000, 3010, 3200, and 3210
Figure 6-79.
OL-16441-01