Cisco TelePresence System Series Hardware Upgrade Manual page 40

Cisco TelePresence Presentation Codec
Step 17 Attach and route the cables between the CTS 1000 and presentation codec.
Figure 3-8
Caution To prevent the codec powering off after a meeting, do not plug the presentation codec power cord into
any of the Switched outlets in the auxiliary control unit. Plug the codec into either the PDU, an electrical
outlet, or the single outlet on the auxiliary control unit that is marked "UNSWITCHED".
If your CTS 1000 does not have an auxiliary control unit, route the Ethernet cables for the Primary Codec
Note
Signal connection directly between the codec and presentation codec. If your CTS 1000 has an auxiliary
control unit, you must disconnect it from the wall to make the Ethernet connections.
Figure 3-8 Power and Signal Cabling for Presentation Codec
Presentation Codec
Signal
Auxiliary Video In
Video out
Microphone
Speaker
Other Possible Configuration
Cisco TelePresence System
3-12
shows you the cabling diagram for a CTS 1000 with a presentation codec.
Back view
Front view
Power Outlet
On/Off Switch
Light Fixture
Camera
Signal
IP Phone
Network
Chapter 3 Options for the Cisco TelePresence System 1000
Auxiliary Control Unit
1 2
SERI AL PORTS RESET
Serial 2
Serial 1
Ethernet 1
Ethernet 2
Codec
Auxiliary Video In
Display
Auxiliary Video Out
Document Camera
1 2
10/ 100 NETW ORK PORTS
OL-16441-01