Cisco TelePresence System Series Hardware Upgrade Manual page 88

Cisco TelePresence Presentation Codec
Step 4 Connect the power cable for the presentation codec to one of the PDUs on the left side of the system.
Cable the presentation codec using the diagram in
Step 5
Figure 6-17 Cable Routing for Cisco TelePresence Presentation Codec
Presentation
display
Serial Video In
(RS232 IN)
Presentation Codec
Signal
Auxiliary Video In
Center
Far
Right
Left
Speaker First Row
Center Microphone
For a Cisco TelePresence system installation that uses an optional document camera, external display,
or HDMI splitter for multiple video displays, use the following wiring diagram for the presentation
codec. If you have an Auxiliary Control Unit, substitute the signal cabling between the presentation
codec and the primary codec with the alternate cabling for the Auxiliary Control Unit.
Cisco TelePresence System
6-22
Video out
Far
Right Center
Left
Audio Expansion
Unit
Chapter 6 Options for the Cisco TelePresence System 3000, 3010, 3200, and 3210
Figure 6-17
Left Codec
Right Codec
Camera
Auxiliary
network
Document Camera
port
IP Phone
Network
or Figure 6-18.
Auxiliary Control Unit
1 2
SER I A L PO R TS R ESET
Serial 2
Serial 1
Ethernet 1
Ethernet 2
Primary Codec
Auxiliary Video In
Display
Auxiliary Video Out
1 2
10/100 NETW O R K PO R TS
OL-16441-01