Cisco TelePresence System Series Hardware Upgrade Manual page 94

Upgrading a CTS 3000 to a CTS 3200
Table elements are heavy, and metal edges can be very sharp. Protect your hands and eyes from injury
Caution
by wearing safety gloves and glasses.
In order to prevent scratching the table tops, you should avoid putting any tools on the shelf surfaces.
Caution
The directions left and right refer to the assembly as you face it from the front.
Note
Table legs are unstable until they are fully attached to the tabletop. Do not use unattached table legs
Warning
as tabletop supports while you attach tabletop segments. They can fall and cause injury or damage.
Cisco suggests you use the accessory cabinets to support and stabilize the table segments as you
install them.
Power down the system. See the
Step 1
Make sure all system power is turned off before beginning the upgrade procedure.
Caution
Replace the existing primary with the new primary codec. See the
Step 2
section on page 6-30
Step 3 Replace the lenses in the camera cluster with the lenses for the CTS 3200. See the
Replacing the Camera Lenses" section on page 6-33
Step 4 Add the audio/video extension unit to the rear of the display assembly. See the
Extension Unit" section on page 6-35
Add the auxiliary control unit to the rear of the display assembly. See the
Step 5
Unit" section on page 6-37
Add the second row table, microphones, I/O modules, and power and signal cables. See the
Step 6
the Second Row Table Assembly" section on page 6-39
Route the cables for the second row table and attach and route the cables for the audio/video extension
Step 7
unit and auxiliary control unit. See
information.
If you require additional information, refer to the
Note
Cisco TelePresence System 3200 Assembly, Use & Care, and Field Replacement Unit
Step 8 Configure Cisco Unified Communications Manager and power on the system. See the
System" section on page 6-96
Step 9 Perform the first-time setup steps and realign the cameras using the instructions in the
Cisco TelePresence System Administrator's
Cisco TelePresence System
6-28
Chapter 6 Options for the Cisco TelePresence System 3000, 3010, 3200, and 3210
"Powering Off the System" section on page 6-29
for more information.
for more information.
for more information.
"Attaching and Routing Cables" section on page 6-88
for more information.
Guide.
"Replacing the Primary Codec"
for more information.
"Adding the Auxiliary Control
for more information.
"Routing Power and Signal Cables"
for more information.
"Removing and
"Adding the Audio/Video
"Building
for more
chapter of the
Guide.
"Powering On the
OL-16441-01