Adding A Cisco Telepresence Presentation Codec With A Auxiliary Control Unit; Configuring A Cisco Telepresence Presentation Codec - Cisco TelePresence System Series Hardware Upgrade Manual

Chapter 2 Options for the Cisco TelePresence System 500-37

Adding a Cisco TelePresence Presentation Codec with a Auxiliary Control Unit

To add a presentation codec to an CTS 500 with an auxiliary control unit, complete the steps in the
"Adding a Presentation Codec" section on page 2-5
•
•
The Ethernet ports in the auxiliary control unit are interchangeable. Use either of the ports for the
Note
connections from the primary codec and the presentation codec.

Configuring a Cisco TelePresence Presentation Codec

To configure the presentation codec with the CTS 500, complete the following steps.
Log in to the Cisco Unified Communications Manager web GUI.
Step 1
Navigate to Device > Phone.
Step 2
Find the Cisco Unified IP Phone that controls your Cisco TelePresence system by clicking Find.
Step 3
Click the hypertext link next to the phone that controls your Cisco TelePresence System to select it.
Step 4
In the Optional Hardware area, click the Presentation Codec check box.
Step 5
Figure 2-12 Presentation Codec Check Box
The options that display in this area might differ from what you see in your system.
Note
Click Save, then, click Apply Config to apply the configuration to your system.
Step 6
OL-16441-01
Connect the Primary Codec Document Camera Ethernet connection (orange Ethernet connection on
the primary codec) to one Ethernet port of the auxiliary control unit.
Connect the other Ethernet port of the auxiliary control unit to the Presentation Codec Ethernet port
(white/red Ethernet connection on the presentation codec).
Cisco TelePresence Presentation Codec
and perform the following additional cabling steps:
Cisco TelePresence System
2-15