Show Interface Linecard Connection-Mode; Show Interface Linecard Link Mode; Show Interface Linecard External-Bypass; Show Rdr-Formatter - Cisco SCE8000 GBE Installation And Configuration Manual

Hide thumbs Also See for SCE8000 GBE:
Table of Contents

Advertisement

Basic Post-Installation Checklist
Resulting current shutdown state is off
WAP handling is disabled

show interface linecard connection-mode

sce>show interface linecard 0 connection-mode
slot 0 connection mode
Connection mode is inline
slot failure mode is external-bypass
Redundancy status is standalone

show interface linecard link mode

sce>show interface linecard 0 link mode
Link mode on all links
Current link mode is
Actual
Actual

show interface linecard external-bypass

sce1>show interface linecard 0 external-bypass
External bypass current state is 'not activated'.
External bypass failure state is 'activated'.
Amount of expected external bypass devices: 4 (automatically configured).
Amount of detected external bypass devices: 4

show RDR-formatter

Look for:
sce>show RDR-formatter
Status:
Connection is: up
Forwarding mode: redundancy
Connection Table:
--------------------------------------------------------------------------------
| Collector
| IP-Address
| Host-Name
|---------------|-------|------|-----------|------------|-----------|-----------|
| 10.240.59.39
| 10.240.59.44
---------------------------------------------------------------------------------
RDR:
UM:
Logger: queued:
Errors: thrown:
Last time these counters were cleared: 07:36:52
Cisco SCE8000 GBE Installation and Configuration Guide
A-8
link mode on active is : forwarding
link mode on failure is: crosspath-bypass
Forwarding mode
Status (in Status column in the Connection Table)
enabled
| Port
|Status| Priority per Category:
/ |
|
|
|
| 33000 | up
| 33000 | up
queued:
0 ,sent:60108106, thrown:
queued:
0 ,sent:
0 ,sent:
0
Appendix A
: crosspath-bypass
|------------------------------------------------|
| Category1 | Category2
|100 primary| ---
| ---
|100 primary | ---
0, format-mismatch:
0, thrown:
0
0, thrown:
0
EDT
CLI Commands to Verify a Successful Installation
| Category3 | Category4 |
| ---
| ---
| ---
0
TUE
April
28
2009
|
|
|
OL-19897-02

Advertisement

Table of Contents
loading

Table of Contents