Removing And Replacing The Fan Assembly; Required Tools; Removing The Fan Assembly - Cisco SCE8000 GBE Installation And Configuration Manual

Removing and Replacing the Fan Assembly

Removing and Replacing the Fan Assembly
This section describes how to remove and replace fan assemblies for the Cisco SCE8000 GBE chassis.
•
•
•

Required Tools

A flat-blade or number 2 Phillips-head screwdriver is required to perform this procedure.

Removing the Fan Assembly

The fan assembly is designed to be removed and replaced while the system is operating without
presenting an electrical hazard or damage to the system.
Loosen the two captive installation screws
Step 1
Figure 9-7 Fan Assembly
SCE 8000
-SC M-E
FA N
ST AT U
S
SCE 8000
-SC M-E
SCE 8000
Captive installation screws
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the fan
blades completely stop before you remove the fan tray.
Step 2 Grasp the fan assembly with both hands and pull it outward; rock it gently if necessary to unseat the
power connector from the backplane.
Pull the fan assembly clear of the chassis, and put it in a safe place.
Step 3
Cisco SCE8000 GBE Installation and Configuration Guide
9-12
Required Tools, page 9-12
Removing the Fan Assembly, page 9-12
Installing the Fan Assembly, page 9-13
OPT ICA L
BYP ASS
CON SOL
E
POR T 1
STA TUS
10 100
LINK
1000
ACT IVE OP TIC AL
BY PAS S
OPT ICA L
BYP ASS
CON SOL
E
POR T 1
STA TUS
10 100
LINK
1000
ACT IVE OP TIC AL
BY PAS S
-SIP
SPA -1X1
0GE -L-V
2
SPA -1X1
0GE -L-V
2
TX
TX
TX
A C
RX TX CT RL
B
RX D
A B
RX
C
RX D
ST AT US
OP TIC AL
BY PA SS OP B- SC
1 E8 K- MM
Chapter 9
(Figure 9-7) by turning them counterclockwise.
SCE 8000
EXTE NDE
D SER VICE
CON TRO
L MOD ULE
MA STE R
SYS TEM
PO WE R
SCE 8000
EXTE NDE
D SER VICE
CON TRO
L MOD ULE
MA STE R
SYS TEM
PO WE R
SPA -1X1
0GE -L-V
2
SPA -1X1
0GE -L-V
2
Removal and Replacement Procedures
OL-19897-02