Rebooting The Sce Platform; Examples For Rebooting The Sce Platform; How To Shut Down The Sce Platform - Cisco SCE8000 GBE Installation And Configuration Manual

Rebooting and Shutting Down the SCE Platform

Rebooting the SCE Platform

Rebooting the SCE platform is required after installing a new package, in order for that package to take
effect. There might be other occasions where rebooting the SCE platform is necessary.
When the SCE restarts, it loads the startup configuration, so all changes made in the running
Note
configuration will be lost. You are advised to save the running configuration before performing reload,
as described in
Step 1 At the SCE# prompt, type reload and press Enter.
A confirmation message appears.
Type y to confirm the reboot request and press Enter.
Step 2

Examples for Rebooting the SCE Platform

The following example shows the commands for system reboot.
SCE# reload
Are you sure? y
the system is about to reboot, this will end your CLI session

How to Shut Down the SCE Platform

Shutting down the SCE platform is required before turning the power off. This helps to ensure that
non-volatile memory devices in the SCE platform are properly flushed in an orderly manner.
When the SCE platform restarts, it loads the startup configuration, so all changes made in the running
Note
configuration will be lost. You are advised to save the running configuration before performing reload,
as described in
Step 1 Connect to the serial console port (The CON connector on the front panel of the Service Control module
in slot #1, 9600 baud).
The SCE# prompt appears.
Type reload shutdown.
Step 2
A confirmation message appears.
Step 3 Type y to confirm the shutdown request and press Enter.
Cisco SCE8000 GBE Installation and Configuration Guide
7-22
Saving or Changing the Configuration Settings, page
Saving or Changing the Configuration Settings, page
Chapter 7 Basic Cisco SCE8000 GBE Platform Operations
7-7.
7-7.
OL-19897-02