Installing A Module - Cisco SCE8000 GBE Installation And Configuration Manual

Chapter 9 Removal and Replacement Procedures

Installing a Module

Choose a slot for the module.
Step 1
Modules must be installed in the proper slots, as follows:
•
•
•
Step 2 At the SCE# prompt, type reload shutdown and press Enter to power down the Cisco SCE8000 GBE
platform before installing or removing any module.
Make sure that there is enough clearance to accommodate any interface equipment that you will connect
Step 3
directly to the module ports.
Verify that the captive installation screws are tightened on all modules already installed in the chassis to
Step 4
ensure that the EMI gaskets on all modules are fully compressed in order to maximize the opening space
for the new or replacement module.
If the captive installation screws are loose, the EMI gaskets on the installed modules will push adjacent
Note
modules toward the open slot, reducing the opening size and making it difficult to install the replacement
module.
Step 5 Remove the module filler plate by removing the two Phillips pan-head screws from the filler plate. To
remove a module, follow the procedure in
Step 6 Fully open both ejector levers on the new module. (See
Figure 9-10
SCE8000-SCM-E
BYPASS1
OL-19897-02
A single SCE8000-SCM-E module must be installed in slot #1.
If a second SCE8000-SCM-E module is used, it must be installed in slot #2.
The SCE8000-SIP module must be installed in slot #3.
Ejector Levers and Captive Installation Screws
OPTICAL
CONSOLE PORT1
10/100/ LINK/
1000 ACTIVE
Removing a Module, page 9-18
Figure
STATUS
OPTICAL BYPASS
OPTICAL
AUX PORT2
BYPASS2
10/100/ LINK/
1000 ACTIVE
Cisco SCE8000 GBE Installation and Configuration Guide
Removing and Replacing Modules
9-10.)
SCE8000 EXTENDED SERVICE CONTROL MODULE
MASTER
SYSTEM POWER
M AS TE R
SY ST EM PO W
ER
Captive
installation
Ejector lever
screws
9-15