Managing Cisco Sce8000 Gbe Configurations; Viewing Configurations - Cisco SCE8000 GBE Installation And Configuration Manual

Chapter 7 Basic Cisco SCE8000 GBE Platform Operations
The following example shows the counters of the first Gigabit Ethernet interface.
SCE#show interface GigabitEthernet 3/0/0 counters
In total octets: 100
In good unicast packets: 90
In good multicast packets: 0
In good broadcast packets: 10
In packets discarded: 0
In packets with CRC/Alignment error: 0
In undersized packets: 0
In oversized packets: 0
Out total octets: 93*2^32+1022342538
Out unicast packets: 858086051
Out non unicast packets: 0
Out packets discarded: 0

Managing Cisco SCE8000 GBE Configurations

After you have installed your SCE8000 GBE platform hardware, checked all external connections,
turned on the system power, and allowed the system to boot up, you are ready to install the Service
Control application. However, before you install the application, you might need to configure the SCE
platform. Instructions for configuring the SCE8000 GBE platform are beyond the scope of this
publication.
For further information on system and interface configuration, refer to the following documents:
•
•
The procedures for managing Cisco SCE8000 GBE configurations are explained in the following
sections:
•
•
•

Viewing Configurations

When you enter configuration commands, it immediately affects the SCE platform operation and
configuration. This configuration, referred to as the running-config, is saved in the SCE platform volatile
memory and is effective while the SCE platform is up. After reboot, the SCE platform loads the
startup-config, which includes the non-default configuration that was saved by the user, into the
running-config.
The SCE platform provides commands for:
•
•
•
After configuring the SCE platform, you may query for the running configuration using the command
show running-config.
OL-19897-02
Cisco SCE8000 GBE Software Configuration Guide
Cisco SCE8000 CLI Command Reference
Viewing Configurations, page 7-5
Saving or Changing the Configuration Settings, page 7-7
Restoring a Previous Configuration, page 7-9
Viewing the running configuration with only user-configured (non-default) values: show
running-config
Viewing the running configuration with all the SCE platform running configuration values, whether
default or not: show running-config all-data
Viewing the startup configuration: show startup-config
Managing Cisco SCE8000 GBE Configurations
Cisco SCE8000 GBE Installation and Configuration Guide
7-5